H106-6 AKCP Locate Rope Water Sensor
0đ
(Chưa VAT)Thông tin sản phẩm
Find the specific position of water leaks over large area
The locate rope water sensor will give you a precise location of the water leak so you can respond promptly to protect your enterprise resources from water damage.
- Product Code: LWS10
- Optional Lengths Available
- Powered by the base unit
This sensor comes fully assembled and includes the rope portion that is the water sensing cable, the non-sensing cable (from the rope to the sensing module) and the main sensing module. The sensing cable can be pre-ordered from a 10 foot minimum to any custom run length (in multiples of 10 feet) of up to 160 feet. The non-sensing cable comes in a standard 20 foot run length.
The specific location of water along the rope can be used to trigger alerts like e-mail, SMS, phone calls and SNMP traps. The sensor has its own SNMP OID so that it can be monitored over the network using any Network Management System.
Each Locate Rope Water sensor comes complete with a 5 foot sensor cable that connects the main sensing module to the AKCP remote monitoring base unit RJ-45 sensor ports, or you can use your own CAT5/6 LAN cable. This cable can be extended up to 100 feet or 30 meters.
Features
- Designed for specific location water detection
- Available in standard and custom lengths
- Own SNMP OID for monitoring across a network
- CAT5 sensor cable extendable to 100 feet
Specifications
| Measurement Type | Wet or Dry Closest location detection |
| Measurement Rate | Multiple readings every second |
| Able to detect the presence of water at specific location | |
| Indication | LED for Status |
| Operating Temperature | -20 °C~60 °C 4 °F~140 °F |
| Pull Force Limit | Not to exceed 50 lb |
| Bend Radius | 2 in. (50 mm) minimum |
| Pressure | Loads greater than 20 lb (9 kg) per linear inch at 20°C (68°F) may immediately trigger an alarm |
| Interface | |
| Communications Cable | RJ-45 jack to sensor using UTP Cat 5 wire |
| Communications Cable Max. length |
The Locate Rope Water Sensor can be extended from the RJ-45 Intelligent Sensor ports on the base units up to 100 feet, or 30 meters using standard CAT5/6 LAN cable. Non-sensing cable comes in a standard 20 feet run length. |
| Power Source | Powered by the controller unit. No additional power needed |
| Full autosense including disconnect alarm | |
| Power Consumption | Typical 125 mWatt, 25 mA |
| Dimensions | 56 x 55 x 33.3 mm |
| Mounting | DIN rail mounting Screw mounting |
| Important Note | AKCP does not recommend the locateWater Sensor to be placed on a conductive surface. |
| Sensor count | 1 |
Download Datasheet
